diff --git a/adafruit_bus_device/spi_device.py b/adafruit_bus_device/spi_device.py
index e1fbc39..7b62649 100644
--- a/adafruit_bus_device/spi_device.py
+++ b/adafruit_bus_device/spi_device.py
@@ -34,11 +34,13 @@ class SPIDevice:
:param ~busio.SPI spi: The SPI bus the device is on
:param ~digitalio.DigitalInOut chip_select: The chip select pin object that implements the
DigitalInOut API.
- :param bool cs_active_value: Set to true if your device requires CS to be active high.
- Defaults to false.
- :param int baudrate: The SPI baudrate
- :param int polarity: The SPI polarity
- :param int phase: The SPI phase
+ :param bool cs_active_value: Set to True if your device requires CS to be active high.
+ Defaults to False.
+ :param int baudrate: The desired SCK clock rate in Hertz. The actual clock rate may be
+ higher or lower due to the granularity of available clock settings (MCU dependent).
+ :param int polarity: The base state of the SCK clock pin (0 or 1).
+ :param int phase: The edge of the clock that data is captured. First (0) or second (1).
+ Rising or falling depends on SCK clock polarity.
:param int extra_clocks: The minimum number of clock cycles to cycle the bus after CS is high.
(Used for SD cards.)
pFad - Phonifier reborn
Pfad - The Proxy pFad of © 2024 Garber Painting. All rights reserved.
Note: This service is not intended for secure transactions such as banking, social media, email, or purchasing. Use at your own risk. We assume no liability whatsoever for broken pages.
Alternative Proxies:
Alternative Proxy
pFad Proxy
pFad v3 Proxy
pFad v4 Proxy