diff --git a/ports/espressif/boards/heltec_esp32s3_wifi_lora_v3/board.c b/ports/espressif/boards/heltec_esp32s3_wifi_lora_v3/board.c
index 317fb0d88a1f0..d0ae146504234 100644
--- a/ports/espressif/boards/heltec_esp32s3_wifi_lora_v3/board.c
+++ b/ports/espressif/boards/heltec_esp32s3_wifi_lora_v3/board.c
@@ -34,10 +34,10 @@ uint8_t display_init_sequence[] = { // SSD1306
digitalio_digitalinout_obj_t display_on;
static void display_init(void) {
- // Need to bring GPIO21 high or the screen doesn't get power
+ // Need to bring GPIO36 high or the screen doesn't get power
// & the board can't see the i2c bus at all.
- common_hal_digitalio_digitalinout_construct(&display_on, &pin_GPIO21);
- common_hal_digitalio_digitalinout_switch_to_output(&display_on, true, DRIVE_MODE_PUSH_PULL);
+ common_hal_digitalio_digitalinout_construct(&display_on, &pin_GPIO36);
+ common_hal_digitalio_digitalinout_switch_to_output(&display_on, false, DRIVE_MODE_PUSH_PULL);
common_hal_digitalio_digitalinout_never_reset(&display_on);
busio_i2c_obj_t *i2c = common_hal_board_create_i2c(0);
@@ -48,7 +48,7 @@ static void display_init(void) {
bus,
i2c,
0x3c,
- NULL
+ &pin_GPIO21 // broken-out on V3
);
busdisplay_busdisplay_obj_t *display = &allocate_display()->display;
pFad - Phonifier reborn
Pfad - The Proxy pFad of © 2024 Garber Painting. All rights reserved.
Note: This service is not intended for secure transactions such as banking, social media, email, or purchasing. Use at your own risk. We assume no liability whatsoever for broken pages.
Alternative Proxies:
Alternative Proxy
pFad Proxy
pFad v3 Proxy
pFad v4 Proxy