chore: Incorporate feedback

zfields · fpistm · commit ed4ef2f6ebba · 2022-10-05T16:54:24.000+02:00
diff --git a/variants/STM32L4xx/L4R5Z(G-I)Y_L4R9Z(G-I)Y_L4S5ZIY_L4S9ZIY/variant_SWAN_R5.h b/variants/STM32L4xx/L4R5Z(G-I)Y_L4R9Z(G-I)Y_L4S5ZIY_L4S9ZIY/variant_SWAN_R5.h
@@ -222,16 +222,6 @@
   #define TIMER_SERVO           TIM7
 #endif
 
-// Pin used for Virtual COM Port
-// Note that a developer would add this to their Arduino project:
-//     HardwareSerial SerialVCP(PIN_SERIAL_VCP_RX, PIN_SERIAL_VCP_TX);
-#ifndef PIN_SERIAL_VCP_RX
-  #define PIN_SERIAL_VCP_RX     PG8
-#endif
-#ifndef PIN_SERIAL_VCP_TX
-  #define PIN_SERIAL_VCP_TX     PG7
-#endif
-
 // UART Definitions
 #ifndef SERIAL_UART_INSTANCE
   #define SERIAL_UART_INSTANCE  1
@@ -246,6 +236,24 @@
   #define PIN_SERIAL_TX         PA9
 #endif
 
+// LPUART1
+#ifndef PIN_SERIAL_LP1_RX
+  #define PIN_SERIAL_LP1_RX     PG8
+#endif
+#ifndef PIN_SERIAL_LP1_TX
+  #define PIN_SERIAL_LP1_TX     PG7
+#endif
+
+// Virtual COM Port for Swans with a 14-pin STLink Connector mounted.
+// To use the STLINK's Virtual COM port, this would be added to an Arduino project:
+//     HardwareSerial SerialVCP(PIN_VCP_RX, PIN_VCP_TX);
+#ifndef PIN_VCP_RX
+  #define PIN_VCP_RX     PIN_SERIAL_LP1_RX
+#endif
+#ifndef PIN_VCP_TX
+  #define PIN_VCP_TX     PIN_SERIAL_LP1_TX
+#endif
+
 // Extra HAL modules
 #if !defined(HAL_DAC_MODULE_DISABLED)
   #define HAL_DAC_MODULE_ENABLED
